WATERFALL VST - Delay & Filter Split

Waterfall has 4 channels, each with its own filter, LFO and delay. The cut-off of all filters can be modulated by the LFO.

The GUI is divided into three sections: On the top left there are basic controls for input/output levels and the stereo expander. The bottom left controls set the level of all channels. The four horizontal strips on the right are the four effect channels. The effects applied to each channel are mixed in the final output.

Description of the parameters

Top left

	input	Adjusts the input level.
	dryout	Adjust the output level of the dry signal.
	expstereo
	(button)	Turns the stereo expander on/off.
	(knob)	Adjusts the wideness of the stereo expander. Has no effect if the mixer pan control is set to a low value.

Bottom left

	cutoff	Sets the cut-off value for all filters.
	resonance	Sets the resonance value for all filters.
	feedback	Sets the feedback value for all delays.
	mix	Adjusts the mix for all delay levels.

Channel settings

	ON/OFF	Turns the channel on/off. Reduce the number of channels to ease the load on a slow CPU.
	Filtertype	Selects the filter type from LPF (low pass filter), HPF (high pass filter) or BPF (band pass filter).

	waveform	Selects the waveform of the filter affecting the channel. Pulse width is fixed at 50%.
	speed	Sets the speed of the LFO.
	amount	Sets the depth of the LFO.

	Delaytime	Sets the delay time of the channel.
	Delay Volume	Adjusts the delay volume of this channel only.

	PAN	Sets the pan position of the output.
	Volume	Sets the volume of the channel.